German
French
Italian
Portuguese
Japanese
Korrean
Russian
Specific steps for testing air purification filter equipment
Specific steps for testing air purification filter equipmentWhat should I do if I encounter a fault when using the filtering equipment?First, we need to stop the operation of the equipment in time, and then according to certain rules for testing, if it is a simple problem can be repaired by the standard. 1. First of all, the electrical equipment in the equipment for the regular inspection, is qualified before being put into use. 2. Check whether the installation of the equipment is smooth, with no swaying, or vibration phenomenon. 3. Check whether the installation of the inlet and outlet pipes of the equipment is correct and whether the external piping is firm, etc. 4. Check whether the external power supply is connected correctly. 5. All rotating parts of the equipment must not be stuck. 6. Check whether the motor steering of the oil pump and vacuum pump in the equipment meets the requirements. After the proper testing of the equipment, we also need to pay attention to many issues in daily use to avoid the same failure problems: 1. Before the operation, staff should first read the manual, familiar with the specific operation of the equipment, strictly by the order of the manual to operate. 2. In the process of use, often check the equipment of the oil pipe joints, and valves whether there is a blockage, or oil leakage, such as found fault should immediately stop for inspection, and processing. 3. In the process of operation, if the outlet oil pressure is greater than 0.3Mpa, the reason should be checked in time. 4. The use of smoke and fire is strictly prohibited at the working site of the equipment. 5. If the heater is used on the equipment, the oil pump should be turned on first, however, the heater is put into operation, and the order of operation when shutting down is reversed. 6. If the heater is used, the heater should be stopped 5 minutes before shutdown. 7. Cut off the power supply and clean up the site after the whole filtration process. |
