German
French
Italian
Portuguese
Japanese
Korrean
Russian
Need to pay attention to cleaning the fast shutter door shower room?
Need to pay attention to cleaning the fast shutter door shower room?When cleaning the goods shower room of the fast-rolling shutter door, the following aspects need to be paid attention to:Safe outage Before cleaning, be sure to cut off the power supply of the cargo shower to prevent personal injury caused by electric shock or accidental start of the equipment during the cleaning process. Choose the right cleaning tools and materials. Use soft rags or sponges and avoid using sharp or hard tools to avoid scratching doors, walls, and equipment surfaces in the shower room. Choose mild cleaners and avoid corrosive cleaners such as strong acids and alkalis to prevent damage to the equipment. If the cargo shower has special cleaning requirements or specified cleaners, they should be used as required. Door cleaning For the curtain of the fast-rolling shutter door, it should be gently wiped to remove the dust and stains on the surface. Pay attention to checking the door curtain for signs of damage, tearing, or aging, if there is a problem should be recorded and reported in time. When cleaning the door rail, carefully remove debris, dust, and dirt in the track to ensure the smooth operation of the door body. You can use a brush or the small brush head of the vacuum cleaner to clean up, and after cleaning, a small amount of lubricating oil can be applied appropriately to reduce friction but be careful to avoid lubricating oil staining on the door curtain. The cargo shower room is clean. Wipe the walls, ceiling, and floor of the shower room with a clean rag to remove dust, stains, and debris. Special attention should be paid to cleaning around the spray nozzle to ensure that the nozzle is not blocked and can blow out the air normally and evenly. Check and clean the air filter according to the filter type and instructions for use. If it is a washable filter, rinse it with clean water or a mild detergent and let it dry. If it is a disposable filter, it should be replaced by the specified replacement cycle. Electrical component protection When cleaning electrical components such as control panels and motors, use dry rags to gently wipe them to prevent moisture from entering the electrical equipment and causing short circuits or other electrical faults. For some electrical parts that are not easy to clean, compressed air can be used to purge and remove dust, but care should be taken to maintain an appropriate distance and pressure to avoid damaging the parts. Check and reset after cleaning. After cleaning, carefully check whether there is any residual cleaning agent, water stains, or debris inside and outside the shower to ensure that all components have been cleaned and are in normal condition. After confirming that it is correct, turn on the power supply and test whether the functions of the fast-rolling shutter door and the cargo shower room are normal, including the opening and closing of the door body, the operation of the shower system, and the sensitivity of the induction system. If any exception is found, rectify the fault and rectify it in time. |
