German
French
Italian
Portuguese
Japanese
Korrean
Russian
Instructions on the use and installation of transfer windows
Instructions on the use and installation of transfer windowsTransfer windows are generally used in clean rooms or areas that require a high degree of cleanliness, the following clean transfer window manufacturers talk about the use of transfer windows and installation methods. We hope that the introduction of these two aspects of the transfer window can allow everyone will use and install the transfer window.Usage 1, the material in and out of the clean area, must be strictly separated from the flow of people, from the production workshop materials dedicated channel in and out. 2、When the material enters, the raw and auxiliary materials will be sent to the workshop raw and auxiliary materials temporary storage room through the transfer window after the person in charge of the process of preparation class organizes the personnel to take off the package or the appearance of the clean treatment; the inner package materials will be sent to the inner package room through the transfer window after the outer package is removed from the temporary storage room. Workshop generalist and the preparation, the person in charge of the internal packaging process for the handover of materials. 3, through the transfer window transfer, must strictly implement the transfer window inside and outside the door "one open and one closed" provisions, the two doors can not be opened at the same time. Open the outer door to put the material into the first closet, and then open the inner door to take out the material, close the door, and so on. 4、When sending out the materials in the clean area, the materials should be transported to the relevant material intermediate station first and then moved out of the clean area according to the opposite procedure when the materials enter. 5、All semi-finished products from the clean area should be sent to the outer temporary storage room through the transfer window and then transferred to the outer packaging room through the logistics channel. 6、Materials and wastes that are very easy to cause pollution should be transported to the non-clean area from its special transfer window. 7, materials in and out of the end, should be cleaned up promptly at the site of the clean pack room or intermediate station and the transfer window of the health, close the transfer window inside and outside the channel door, and do a good job of cleaning and disinfection. The installation method of the transfer window: Choose a convenient location in the wall, and then open a hole, the hole is generally larger than the outer diameter of the transfer window about 10MM, put the transfer window into the wall, generally installed in the middle of the wall, to maintain a balanced fixation, with rounded corners or other decorative strips to decorate the transfer window and the wall of the gap, glue sealing modification can be. |
