News

Experienced people tell you the correct way to operate a  leak test benches

1. Check whether the power supply is connected and whether it meets the requirements of the instruction manual before starting the leak detection table, and clean up the debris above.

2. Add pure water to the sink of the leak detection table, the liquid level should be lower than the smoke outlet by about 2mm, and fill the water tank with tap water, the liquid level should be kept within the range of the upper and lower scale.

3. Close the built-in switch of the electrical cabinet, when the "power" indicator light is on, it means that the power is on.

4. Press the "Power On" button and the equipment will start to warm up.

5. Place the activated carbon filter to be tested horizontally on the sink, the center of the filter should be aligned with the center of the smoke outlet.

6. Adjust the brightness and the height of the spotlight through the buttons on the operating panel.

7. Press the "detect" button when the preheat light is on, then observe whether there is smoke spillage in the filter, the spillage is the leak point, mark the leak point and remove the filter.

8. When shutting down, just press the "shutdown" button.

9. If you encounter an emergency in use, press the "emergency stop" button directly to cut off the power.

10. After the whole testing process is finished, you need to turn off the power and drain the water in the sink in time.