German
French
Italian
Portuguese
Japanese
Korrean
Russian
Air Shower Room Configuration
Air Shower Room Configuration1. Material and structure A stainless steel air shower room is better than a color steel plate and color steel plate air shower room. Comparison of air showers made of the same material depends on the thickness of the steel plate. DXN Zhiyuan air shower steel plate thickness of 1.5mm, than the ordinary air shower steel plate 0.8mm-1mm structure and reliable, structural reinforcement of the air shower service life than the non-reinforced longer, not easy to deformation. The air shower room with adhesive sealing technology is superior to the air shower room directly using sealing tape. 2. Control system At present, the air shower room is fully automatic control, but the boutique intelligent air shower room will be equipped with LCD control, and the system will be linked with all parts of the air shower room. LCD screen displays wind speed, blowing time, differential pressure, electrical equipment failure alarm, and fault location. A wind shower equipped with a control panel can only display the blowing time, which is far from the intelligent wind shower function. Wind shower time, An intelligent wind shower room can be set freely and can be in 1-99s. 3. Wind speed Adjustment within the range. The results show that when the wind speed is greater than 20m/s, the dust removal efficiency is close to the high value, and with the increase of wind speed, the change range is small; in the same wind speed, the larger the particle size, the better the dust removal effect. Because the air shower room is located between the clean area and non-clean area, frequent use, the resistance of the filter screen rises rapidly. Therefore, although the initial wind speed of most air shower rooms is above 20m/s and can pass the acceptance test, after using it for some time, the wind speed will be reduced, and the dust removal efficiency will drop sharply. Therefore, the initial wind speed of the new air shower room should not be less than 25m/s. 4. Nozzle Nozzles are generally arranged on both sides of the air shower room, and every 6 nozzles are connected to one side. Adjustable nozzle direction is better than fixed nozzle direction. This is because when the high wind speed blows over the surface of the object, it will directly take away the dust on the surface of the object. If dust is strongly attached to the surface of an object, or if dust is attached to the seams of a fabric, the dust removal effect of high-speed air blowing directly onto the surface of the object will be poor, especially if the dust seeps into the seams of the fabric. Therefore, to make the clothes vibrate, it is good to blow air at a certain angle to the surface of the clothes, usually 30-60 degrees. |
